Copyright Gianni Industries, Inc. All Rights Reserved.
P-MU-DG600 Ver. B Publish:2004.08.27 Page: 5/ 6
V. Operation Instruction
WARNING: Please read all of operation instruction before proceeding.
Enter Program Mode
Enter twice the master code : (Default setting is "12345") → Yellow LED will light up →
you are now in the “Programming Mode”.
Exiting from the Program Mode
Press 「#」 → to exit from the programming mode, or if no activation has happened
for 25 seconds , the system will return to the user mode.
System Setting Access Mode
Enter the Programming Mode, Press 「＊ 0」+ 「??」
A. Proximity Only: For Using Card/Tag Only.
?? = 00, setting complete.
B. Proximity or PIN Code to open the door:
?? = 01, setting complete.
C. Proximity + PIN to open the door: Card followed by PIN code to enter.
?? = 02, the setting is complete.
Note 1: After using the proximity card the yellow LED blinks and input the PIN codes. If
wrong PIN code is input it will automatically return to the “User Mode”.
Note 2: 5 continuous wrong pin codes will automatically deletes the card.
Adding and deleting cards
Enter the Programming Mode, Press the card storage slot code： 000~599
A. Green light comes on: This slot code may register the card
I. Show card to readerÆYellow light blinks Æ input 5 digits PIN codes Æ Green light
offÆ enrolled completed Æ（repeat）
II. Show card to readerÆ (4 audible beep) another card has already been input
(duplicate card).
B. Red light comes on: This slot already has a code registered
I. Press 「＊＊」 (deletion) Æ Green light comes on Æ Show card to reader Æ
﹝same as step “A-1”﹞
II. Enter another slot card position.
Note 1: Regardless of system setting access mode select, you must enter a 5-digit PIN
codes after showing the card to complete the register program, otherwise the card
input will not be successful.
Note 2: The master code are not be used for PIN code.
Relocking timer setting
Enter the Programming Mode, Press 「＊1」+「??」
A. Pulse mode:?? = 01~99 seconds, 05 represents 5 seconds → (An audible beep)
indicates setting successfully→to exit from the programming mode, or program other
operating.
B. Latching mode:?? = 00 → (An audible beep) indicates setting successfully→to exit from
the programming mode, or program other operating.
Note: Enter「00」Sets the relay to latching mode. (Correct code or card entered opens the
relay, and the relay stays open until the correct code or card is entered again).
(1 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales